Version 6.6 827 October 2014
Installation & Operation Manual 46. Online Software Upgrade
46.5 After Completing the Online Software Upgrade
Note: After completing the Online Software Upgrade, perform software backup as
described in 'SC Software Backup/Restore Procedures' on page 774 to assure
backup availability should it be required later.
After you complete the Online Software Upgrade Wizard, the Media Gateway software
and all of its components are upgraded to the new software version. However, some
new features of the software may not be automatically activated.
The following table lists the most important features of the Version 6.6 software that
are not automatically activated when you upgrade from earlier major versions. You
should manually activate these features as described in the relevant section.
Table
46-1: New Features of Version 6.6 Software that must be Manually Activated after
Upgrading from an Earlier Version
Feature Name Detailed Description
Remote access by root
user
Remote access by root user is disabled on newly installed Version 6.6
software.
However, when you perform upgrade from an earlier software version
where remote root access was enabled, the configuration remains
unchanged to simplify the transition to the new software.
After completing the Online Software upgrade, you must manually
disable remote access by root user as it poses a severe security risk.
For more information, seeFor more information, see Section Section
'Disabling a Direct Remote Login' on page 311.
Ensure that at least one CLI user is defined on both SC boards and
provisioned with a known password. Otherwise, you will be unable to
establish connection with the SC board's terminal over the IP network.
For more information, see Section 'Command Line Interface' on page
107.
To Next Page
Loading...
Need help?
General
