Installation & Operation Manual 194 Document # LTRT-92224
Mediant 8000
Initial State Event Taken Action & New State
2
nd
ES board is active
2 of 3 aggregated links are up
on both ES boards.
Failed link on the 1
st
ES
board returns to service.
Switchover to the 1
st
ES board (where
all aggregated links are up).
26.2.6.5 Configuring Media Link Aggregation
This section describes how to configure Media Link Aggregation.
To configure media link aggregation:
1. Click
to access the Media Gateway status screen.
2. In the Navigation pane, click Networking and then in the configuration pane,
click Network Settings; the Network Settings screen is displayed.
3. In the Interfaces and VLAN Settings tab, configure the link aggregation
parameter as described in the table below.
Table
26-2: Media Link Aggregation Settings
Parameter Name Type
Provisioning
Type
Description
Media Aggregation
Enable
Enum
Disable,
Aggregate2,
Aggregate3
Online Defines link aggregation mode for
media subnets:
Disable – disable link aggregation
(use this configuration when four
or less TP-6310 or TP-8410 Media
Gateway boards are installed in
the chassis)
Aggregate2 – use 2 aggregated
links (use this configuration when
five to six TP-6310 or TP-8410
Media Gateway boards are
installed in the chassis)
Aggregate3 – use 3 aggregated
links (use this configuration when
more than six TP-6310 or TP-8410
Media Gateway boards are
installed in the chassis)
To Next Page
Loading...
