AudioCodes Mediant 8000 - Mediant

Installation & Operation Manual 602 Document # LTRT-92224
Mediant 8000
Parameter
Name
Type
Provisioning
Type
Description
Preference IPv6Only,
IPv4Only
(Connection) of the SDP.
 Only IPv4 – offer includes only IPv4
media IP addresses (default).
 Only IPv6 – offer includes only IPv6
media IPs addresses.
 Prefer IPv4 – offer includes both IPv4 and
IPv6 media IP addresses, but the first
media is IPv4.
 Prefer IPv6 – offer includes both IPv4 and
IPv6 media IP addresses, but the first
media is IPv6.
Notes:
 This parameter is applicable only when
the device offers an SDP.
 The IP addressing version is determined
according to the first SDP "m=" field.
 This parameter can be also configured
per IP Profile ID.
Enable Ptime Enum
Disable, Enable
Instant Defines whether the ptime header is
included in the SDP.
Multi Ptime
Format
Enum
None, Packet
Cable
Instant Defines whether the 'mptime' attribute is
included in the outgoing SDP.
The 'mptime' attribute enables the gateway
to define a separate packetization period for
each negotiated coder in the SDP. The
'mptime' attribute is only included if this
parameter is enabled, even if the remote
side includes it in the SDP offer. On receipt,
each coder receives its 'ptime' value in the
following precedence:
 From 'mptime' attribute.
 From 'ptime' attribute.
SDP Session
Owner
String
Up to 39 chars
Instant Defines the value of the Session Owner line
('o' field) in outgoing SDP bodies.
Fax Signaling
Method
Enum
No Fax
Negotiation Using
SIP Signaling,
Initiates T38 Fax
Relay, Initiates
Fax Using G.711,
Initiates T38 Fax
Relay With G.711
Instant Defines the SIP signaling method for
establishing and transmitting a fax session
after a fax is detected.
 No Fax Negotiation – No fax negotiation
using SIP signaling. Fax transport
method is according to the parameter Fax
Transport Mode.
 Initiates T.38 Relay – Initiates T.38 fax
relay.