AudioCodes Mediant 8000 - Configuring Query Attribute Key

Installation & Operation Manual 644 Document # LTRT-92224
Mediant 8000
8. Alternative route: If the call routing to all the above fails (e.g., due to unavailable
destination - call busy), the device can route the call to an alternative destination
if an alternative routing rule is configured.
9. "Redundant" route: If the query fails (i.e., no attribute found in the AD), the
device uses the routing rule matching the "LDAP_ERR" prefix destination
number value.
40.15.3 Configuring Query Attribute Key
This section describes how to configure the query attribute key.
1. Click
to access the Media Gateway status screen.
2. In the Navigation pane, select VoIP board, in the Navigation pane, select SIP
SIP General, and then in the Configuration pane, select SIP Protocol Settings.
3. In the LDAP tab, Configure LDAP Query Attributes.
Table
40-25: Query Attribute Key
Parameter
Name
Type
Provisioning
Type
Description
LDAP Server ENUM Offline This parameter associates VOIP Board
with LDAP server. A server name could
be selected from previously configured
LDAP servers list.
LDAP Server
Connection
Status
Read only
parameter
The parameter describes connection
status between VOIP board and LDAP
server.
The possible statuses are:
NotApplicable The LDAP server not
configured or board isn’t assotiated to
LDAP server
ConnectionBroken,
Connecting,Connected
LDAP PBX
NUM Attribute
Name
String
Default:
telephoneNumber
Instant
This attribute telephoneNumber
represents PBX telephone number in
Active Directory.
LDAP Lync
NUM Attribute
Name
String
Default:
msRTCSIP-Line
Instant
This attribute msRTCSIP-Line represents
Lync number in Active Directory.
LDAP Mobile
NUM Attribute
Name
String
Default:
mobile
Instant
This attribute mobile represents mobile
number in Active Directory.