Version 6.6 331 October 2014
Installation & Operation Manual 33. Configuring Security Settings
33.10.4 Adding Certificates to the Auxiliary Files Repository
After successfully generating the CSR and submitting it to the CA, you receive a
digitally signed X.509 Certificate file from the CA. You should also have a certificate of
the CA itself (for verification purposes) and a certificate of Trusted Root (depending on
the PKI scheme that is implemented). All these files must be added to the Auxiliary
Files repository prior to configuring them in the Media Gateway. For more information,
see Section the section 'Auxiliary Files Repository' on page 422.
33.10.5 Activating the new X.509 Certificates on the Media Gateway
Once certificate files are added to the Auxiliary Files repository, take the following
steps to activate the new X.509 configuration on the Media Gateway:
Configure X.509 files in the Media Gateway Security Settings tab.
Apply new X.509 configuration to the Media Gateway boards. See below.
To configure X.509 Security with the Media Gateway:
1. Click
to access the Media Gateway status screen.
2. In the Navigation pane, select Security and then in the configuration pane, click
Security Settings; the Security Settings screen is displayed.
3. In the X.509 Certificates tab, configure new X.509 files as described in the table
'Media Gateway Security Settings' below.
To Next Page
Loading...
