AudioCodes Mediant 8000 - Configuring IP Subnets; Table 26-3: Subnet Properties

Version 6.6 199 October 2014
Installation & Operation Manual 26. Connecting the Media Gateway to the IP Network
26.4.1.1 Configuring IP Subnets
This section describes how to configure IP Subnets.
 To configure IP Subnet:
1. Click the
to access the Media Gateway status screen.
2. In the Navigation pane, select Networking
Subnets; the Subnets list is
displayed.
3. Use
or buttons to add or remove entries.
4. Select a specific row and then in the configuration pane, click Subnet Settings;
the Subnet Settings screen is displayed.
5. Configure the Subnet properties according to the 'Subnet Properties' table below.
Table 26-3: Subnet Properties
Parameter Name Type Provisioning Type Description
Subnet Name String
Up to 16 chars.
Online Defines the textual name
assigned to the Subnet,
enabling it to be easily
identified.
Interface Enum
OCM, CM, OC, C, M,
OLAN, LAN, WAN,
OAM
Online Defines the network
interface used to connect
Mediant 8000 to the
specific IP subnet.
Subnet Type Enum
OAM(0), Media(1),
Control(2), OAM &
Control(4), Media &
Control(5), All(6)
Online Defines type of the IP
traffic carried by the
subnet.
Interface Mode Enum
IPv4, IPv6
Online Defines IPv6 or IPv4
address mode.
Subnet IP String
Up to 40 chars.
Online Defines the subnet IP
address.