Version 6.6 317 October 2014
Installation & Operation Manual 33. Configuring Security Settings
Table 33-1: Filesystem Integrity Status Parameters
Parameter Name Type Provisioning Type Description
File System Integrity
Status
Enum,
ok/failure
Read-only Indicates File System
Integrity Status.
Integrity Unauthorized
Files
String Read-only When unauthorized
modifications to the file
system are detected,
the exact names of the
modified files are listed.
This attribute has a
limited length. For a
complete list of modified
files, use the command
tools fs status as
described below.
When unauthorized modifications to the file system are detected, the File System
Integrity Status attribute of the corresponding SC board is changed to failure and the
Integrity Unauthorized Files attribute is updated with the list of modified files.
However, if the list of modified files is too long, it may not fit into the Integrity
Unauthorized Files attribute. The following procedure enables you to view a
complete list of modified files.
To view the advanced File System Integrity Status (via CLI):
1. Connect to the CLI interface on the specific SC board. For more information, see
Section 'The Command Line Interface (CLI)' on page 107.
2. Login as a CLI user with administrative privileges (e.g. acladmin). For more
information, see Section 'Logging into the Command Line Interface' on page 115.
3. At the prompt type tools fs status and press Enter.
To Next Page
Loading...
