Version 6.6 797 October 2014
Installation & Operation Manual 45. Hardware Replacement
5. Fasten the screws on the front plate of the board to secure the board to the
chassis and to ensure that the board has an earth connection to the chassis.
Connect the cables as detailed below.
45.3.2.1 Connecting Cables to Media Gateway's RTM Module
See 'Connecting to the PSTN Network' on page 122 for detailed instructions on
connecting PSTN cables to Media Gateway boards and RTM modules.
45.4 Adding Media Gateway Boards to a Mediant 8000
System
You can add additional Media Gateway boards to a system that was originally ordered
with less than the full capacity of Media Gateway boards.
To add a Media Gateway board to a Mediant 8000 system:
1. Locate the desired empty slot in the Mediant 8000 chassis. See the constraints
for adding Media Gateway board listed in the following section.
2. Insert the TP-6310 or 8410Media Gateway board into the designated slot in the
front of the chassis. For more information, see Section .'Replacing Media
Gateway Boards' on page 795.
3. Insert the RTM module – 6310/RTM or or 8410/RTM – into the designated slot in
the rear of the chassis. For more information, see Section 'Replacing the Media
Gateway Board's RTM Module' on page 800.
4. To add a board to the Media Gateway software, in the EMS, right-Click the slot
and from the popup menu, select Add Board. See the AddBoard action
described in 'Media Gateway Board Actions' on page 247.
5. Provision the Media Gateway board's parameters and relevant applications. See
'Configuring & Operating the Media ' on page 155Gateway for details.
6. When the configuration is complete, to unlock the Media Gateway board, right-
Click it and from the popup menu, select Maintenance>Unlock.
To Next Page
Loading...
