Installation & Operation Manual 342 Document # LTRT-92224
Mediant 8000
SNMP Management Mode Actual mode of Operation
SNMPv3
An IPSEC/IKE association should not be configured for
SNMP managers. The SNMPv3 protocol has built-in
security features, the result of which renders IPSEC/IKE
abundant and irrelevant.
If, for any reason, the IPSEC/IKE association is configured
for specific SNMP manager, the SNMPv3 traffic will bypass
the encryption (i.e. will not be encrypted via IPSEC/IKE).
To add and configure SC IPSEC Rule:
1. Click
to access the Media Gateway status screen.
2. In the Navigation pane, select Security SC IPSEC Rules; the SC IPSEC Rules
list is displayed.
3. Use the
or buttons to add or remove entries.
4. Select a specific row and then in the configuration pane, click SC IPSEC Rule
Settings; the SC IPSEC Rules Settings screen is displayed.
5. Configure the SC IPSEC Rule parameters according to the table below.
Table
33-7: SC IPSEC Rule Parameters (SC Boards)
Parameter Name Type
Provisioning
Type
Description
Name String
Up to 80 chars.
Instant Textual name of the SC IPSEC Rule, used
for easy identification.
Operation Mode Enum
Transport, Tunnel
Online Defines IPSEC operation mode.
Tunnel operation mode is supported on SC
Rev.2 (Linux OS based) boards only.
Local IP Address Enum
Any, Global IP,
Local IP
Online Defines local IP address of the IPSEC SA.
Remote IP
Address
String
Up to 30 chars
Online Defines the remote IP address of the
IPSEC SA. Applicable for Transport mode
only.
Remote Tunnel
IP Address
String
Up to 30 chars
Online Defines the IP address of the remote
IPSEC tunneling device. Applicable for
Tunnel mode only.
Remote Subnet
IP Address
String
Up to 30 chars
Online Defines the IP address of the remote
subnet (behind the IPSEC tunneling
device). Applicable for Tunnel mode only.
To Next Page
Loading...
