AudioCodes Mediant 8000 - Page 343

Version 6.6 343 October 2014
Installation & Operation Manual 33. Configuring Security Settings
Parameter Name Type
Provisioning
Type
Description
Remote Subnet
Prefix Length
Integer
0 – 128
Online Defines the prefix length of the Remote
Subnet IP Address. Applicable for the
Tunnel mode only.
Local Port Integer
0 – 65535
Online Defines the local port of the IPSEC SA.
Value 0 means 'any'.
Remote Port Integer
0 – 65535
Online Defines the remote port of the IPSEC SA.
Value 0 means 'any'.
Protocol Integer
0 – 255
Online Defines the IP protocol of the IPSEC SA.
Value 0 means 'any'. Commonly used
values: 6 = TCP, 17 = UDP
Authentication
Mode
Enum
Preshared Key,
Certificate
Online Defines authentication mode.
X.509 Certificate authentication mode is
supported on SC Rev.2 (Linux OS based)
boards only.
Preshared Key String
Up to 100 chars
Online Defines the Pre-Shared Key in ASCII
format. Applicable for Preshared Key
authentication mode only. Once
provisioned, the value is hidden from user
via asterisks (*****) for security reasons.
IKE Lifetime
(sec)
Integer
0 – 2147483647
Online Defines the IKE SA Lifetime (in seconds).
IPSEC Lifetime
(sec)
Integer
0 – 2147483647
Online Defines the IPSEC SA Lifetime (in
seconds).
DPD Delay (sec) Integer
0 – 2147483647
Online Activates Dead Peer Detection (DPD) and
sets the time (in seconds) allowed between
2 proof of liveness requests. Value 0
disables DPD monitoring, but still
negotiates DPD support.
Supported on SC Rev.2 (Linux OS based)
boards only.
DPD Retry (sec) Integer
0 – 2147483647
Online If DPD is activated, sets the the delay (in
seconds) to wait for a proof of liveness
before considering it as failed and sending
another request.
Supported on SC Rev.2 (Linux OS based)
boards only.