Installation & Operation Manual 244 Document # LTRT-92224
Mediant 8000
7. When prompted to apply the new network configuration, type y and press Enter.
Apply new configuration? ([y]/n) : y
SC board must be rebooted to activate the new
network configuration.
Reboot now? ([y]/n) : y
8. The SC board will be rebooted and will become accessible via the IP network.
27.7.6 Installing the Linux OS from the USB CD/DVD Drive via the
RS-232 Serial Console
Instead of a bootable USB Flash Drive, a USB CD/DVD drive (to be provided by the
customer) may be used to perform the Linux OS installation on the SC board. The
installation instructions for both mechanisms are very similar.
To start the OS installation:
1. Connect the USB CD/DVD drive to one of the available USB ports on the SC
board’s front panel.
2. Insert the “Linux OS for SC Boards” installation CD-ROM into the CD/DVD drive.
3. Connect to the RS-232 serial console on the SC board, reboot the SC board and
proceed with the installation from step 2 as described in 'Installing the Linux OS
from the USB Flash Drive via the RS-232 Serial Console' on page 238.
To Next Page
Loading...
