Version 6.6 417 October 2014
Installation & Operation Manual 36. Media Gateway Boards' Configuration Backdoor
36 Media Gateway Boards' Configuration
Backdoor
Media Gateway Boards are normally configured via the management objects (MOs)
in the Mediant 8000 Media Gateway 's configuration database. The configuration is
performed via the dedicated EMS GUI configuration screens (described in the
corresponding sections of this manual) or via the CLI interface.
In an unlikely event that you need to configure a parameter for the Media Gateway
board that does not exist in the Mediant 8000 Media Gateway configuration database,
you can use the Media Gateway Board's Configuration Backdoor for provisioning such
parameters.
Prior to configuring the Media Gateway Board's Configuration Backdoor you must
receive the following information from AudioCodes Tech Support:
The parameter's ini file name
The parameter's ini file value
The parameter's ini file value for the redundant board
The update mode
The redundancy mode
To configure Media Gateway Board's Configuration Backdoor, take these 6
steps:
1. Click the
button to access the Media Gateway status screen.
2. In the Navigation pane, select Troubleshooting and then in the configuration
pane, click Troubleshooting Settings; the Troubleshooting Settings screen is
displayed.
3. Select the Configuration Backdoor tab. The list of VoP Board Configuration
backdoors is displayed.
4. Use the
or buttons to add or remove entries.
5. Configure the VoP Board Configuration Backdoor parameters according to the
'Configuration-Backdoor Parameters' table below.
6. Right click on the specific entry and choose Unlock to activate the backdoor
configuration.
To Next Page
Loading...
