AudioCodes Mediant 8000 - Table 40-15: IP Group Parameters

Installation & Operation Manual 612 Document # LTRT-92224
Mediant 8000
6. Configure the IP Groups parameters according to the table 'IP Group Parameters'
below.
7. Click the Maintenance icon
, and then select Unlock to activate the
configuration.
Table
40-15: IP Group Parameters
Parameter Name Type Provisioning Type Description
Name String
Up to 20 chars.
Instant User-defined name (Textual),
assigned to the IP Group, enabling
users to identify it intuitively and
easily.
IP Group Type Enum
Server, User,
Gateway
Instant The IP Group type:
 SERVER – used when the
destination address (configured
by the Proxy Set) of the IP
Group (e.g., ITSP, Proxy, IP-
PBX, or Application server) is
known.
 USER – represents a group of
users (such as IP phones and
softphones) where their location
is dynamically obtained by the
device when REGISTER
requests and responses
traverse (or are terminated) by
the device. These users are
considered remote (far-end)
users.
Typically, this IP Group is
configured with a Serving IP
Group that represents an IP-
PBX, Application or Proxy
server that serves this USER-
type IP Group. Each SIP
request sent by a user of this IP
Group is proxied to the Serving
IP Group. For registrations, the
device updates its internal
database with the AOR and
contacts of the users.
Digest authentication using SIP
401/407 responses (if needed)
is performed by the Serving IP
Group. The device forwards
these responses directly to the
SIP users.
To route a call to a registered