Version 6.6 613 October 2014
Installation & Operation Manual 40. General SIP Configuration
Parameter Name Type Provisioning Type Description
user, a rule must be configured
in the 'Tel to IP/Outbound
Routing' table. The device
searches the dynamic database
(by using the request URI) for
an entry that matches a
registered AOR or Contact.
Once an entry is found, the IP
destination is obtained from this
entry, and a SIP request is sent
to the destination. The device
also supports NAT traversal for
the SIP clients that are behind a
NAT. In this case, the device
must be defined with a global IP
address.
GATEWAY – used to indicate
that a specific group is used for
the Tel-to-IP application only.
Proxy Set Integer
0-32
Instant Selects the Proxy Set (defined in
'Proxy Sets Table') to associate
with the IP Group. All INVITE
messages configured to be 'sent' to
the specific IP Group are sent to
the IP address associated with this
Proxy Set.
Note: The Proxy Set is only defined
for SERVER type IP Groups.
To Next Page
Loading...
