Installation & Operation Manual 614 Document # LTRT-92224
Mediant 8000
Parameter Name Type Provisioning Type Description
SIP Group Name String
Up to 49 chars.
Instant The request URI host name used
in INVITE and REGISTER
messages that are sent to this IP
Group, or the host name in the
From header of INVITE messages
received from this IP Group. If not
specified, the value of the global
parameter Proxy Name (see 'Proxy
/ Registration Parameters') is used
instead.
Note: If the IP Group is of type
USER, this parameter is used
internally as a hostname in the
request URI for TDM-to-IP initiated
calls. For example, if an incoming
call from the device's T1 trunk is
routed to a USER-type IP Group,
the device first forms the request
URI
(destination_number@SIPGroupN
ame), and then it searches the
User's internal database for a
match.
Serving IP Group Integer
-1 (Not Defined) or
1-32
Instant If configured, INVITE messages
initiated from the IP Group are sent
to this Serving IP Group. In other
words, the INVITEs are sent to the
address defined for the Proxy Set
associated with this Serving IP
Group. The Request URI host
name in these INVITE messages
are set to the value of the
parameter 'SIP Group Name'
defined for the Serving IP Group.
Notes:
If the parameter Prefer Route
Table is Enable, the routing
rules in the 'Tel to IP/Outbound
IP Routing' table takes
precedence over this
parameter.
If this parameter is not
configured, the INVITE
messages are sent to the
default Proxy or according to
the 'Tel to IP/Outbound IP
Routing' table.
To Next Page
Loading...
