Installation & Operation Manual 854 Document # LTRT-92224
Mediant 8000
49.4.2 Collecting Call Data Records (CDRs) on MEGACO Boards
This section describes how to collect Call Data Records (CDRs) on MEGACO boards.
To collect CDRs from the MEGACO board:
1. Click
to access the Media Gateway status screen.
2. In the Navigation pane, select Media and then in the configuration pane, click
Media Server Settings; the Media Server Settings screen is displayed.
3. Set Enable NFS Server On SC Board parameter to Enable.
4. Connect to the CLI interface on the Active SC board. For more information, see
Section 'Command Line Interface' on page 107.
5. Login as a CLI user with administrative privileges (e.g. acladmin). For more
information, see Section 'Logging into Command Line Interface' on page 115.
6. To start CDR recording, at the prompt, type tpCmd moBoard#X /cp/cdr start
and press Enter. Replace X with the number of the Media Gateway board for
which you want to record CDRs.
client238::~# tpCmd moBoard#7 /cp/cdr start
7. To stop CDR recording, at the prompt, type tpCmd moBoard#X /cp/cdr stop
and press Enter.
client238::~# tpCmd moBoard#7 /cp/cdr stop
8. To send recorded CDR data to the Active SC board via NFS protocol, at the
prompt, type tpCmd moBoard#X /cp/cdr send file://sc-ip-address/filename
.
Replace sc-ip-address with the Global IP address of the Active SC board and
filename with the full name of the CDR file to be created.
client238::~# tpCmd moBoard#7 /cp/cdr send
file://10.7.9.245/Project/bin/log/cdr /cdr.txt
Note: It is also possible to directly transmit CDR data to any NFS server instead of
the Active SC board. To do so, use IP address of the NFS server and corresponding
directory in the above command.
9. To view recorded CDR data, at the prompt, type more <filename>.
client238::~# more /Project/bin/log/cdr/cdr.txt
10. After you complete the CDR recording, open the Media Settings screen as
described in step 2 and set Enable NFS Server On SC Board parameter to
Disable.
To Next Page
Loading...
