AudioCodes Mediant 8000 - IP Groups Table; Configuring the IP Group Table

Version 6.6 611 October 2014
Installation & Operation Manual 40. General SIP Configuration
40.6 IP Groups Table
Use the IP Groups table to define logical entities that represent a group of SIP users
(e.g. IP phones, gateways or proxy servers) that communicate with the Mediant 8000.
The IP Groups can be used as follows:

To determine the destination entity in the ‘Tel to IP / Outbound Routing’ and
‘Account Group’ tables

To identify source entity in the ‘IP to Tel / Inbound Routing’ table
Each IP Group may be assigned with various parameters that affect formatting of the
SIP messages headers and/or other SIP protocol-specific behavior.
40.6.1 Configuring the IP Group Table
This section describes how to configure the IP Group Table.
 To configure the IP Group Table:
1. Click
to access the Media Gateway status screen.
2. Select the desired SIP board.
3. In the Navigation pane, select SIP
SIP General SIP Control Network IP
Groups; the IP Groups list is displayed.
4. Use the
or buttons to add or remove entries.
5. Select a specific row and then in the configuration pane, click IP Group Settings;
the IP Group Settings screen is displayed. .
The IP Group configuration frame is divided into the following tabs:
• General Settings – these settings are relevant for all SIP applications:
Gateway, IP-to-IP ,SAS, and SBC.
• Gateway Setting- The parameters under this tab can be configured for the
Gateway and IP-to-IP applications only.
• SBC Settings- The parameters under this tab can be configured for the SBC
application only.