Installation & Operation Manual 114 Document # LTRT-92224
Mediant 8000
By default, the following CLI users are available:
Table
17-2: Command Line Interface Users
Command Line
Interface Users
Default
Password
Type Description
root root Superuser
root user is a superuser who has
unrestricted permissions on the SC board.
Use it to perform OS configuration tasks
and Mediant 8000 software installation.
Note: Some commands, available to root
user, may cause serious damage to the SC
board’s software, therefore use this user
only where appropriate and with a great
caution.
acladmin pass_1234 CLI administrator
acladmin is a default CLI user created
during the Mediant 8000 installation. Use it
to perform most maintenance and
configuration tasks.
Note, however, that the acladmin is a
regular CLI administrator user and
therefore may be deleted and other CLI
users may be created instead of it. Refer to
'Administering Command Line Interface
Users' on page 361
ems N/A EMS User
The ems user is used by the Element
Management System (EMS) to perform
maintenance tasks on the Mediant 8000
(e.g. to perform Online Software Upgrade).
It has permissions equivalent to the CLI
administrator user.
It is strongly recommended not to remove
the ems user from the SC board’s CLI,
otherwise some maintenance tasks that
are performed via EMS may be
unavailable.
Additional CLI users may exist on the SC board as a result of CLI users' administration
and/or synchronization with EMS users. Refer to 'Administering Command Line
Interface Users' on page 361 for more information.
To Next Page
Loading...
