Version 6.6 197 October 2014
Installation & Operation Manual 26. Connecting the Media Gateway to the IP Network
26.3.1 Additional OAM Subnet Configuration
In addition to the above-described configuration, the following additional OAM Subnet
parameters may be configured on the Mediant 8000.
The Mediant 8000 may be configured for two additional OAM (management) subnet
segments. For each segment, the following parameters must be configured:
VLAN Tag ID – VLAN tag to be used by this additional OAM (management)
subnet segment.
Subnet Mask – subnet mask of this additional OAM (management) subnet
segment.
SC1 and SC2 IP Addresses – private IP addresses of the SC boards located in
Slots 1 and 2 correspondingly in this additional OAM (management) subnet
segment.
Global IP Address – global (virtual) IP address assigned to the active SC board in
this additional OAM (management) subnet segment.
To perform additional configuration of OAM subnet:
1. Click
to access the Media Gateway status screen.
2. In the Navigation pane, click Networking and then in the configuration pane,
click Network Settings; the Network Settings screen is displayed.
3. In the Additional OAM Subnet tab, configure additional OAM subnet parameters
as described above.
In addition, Quality of Service (QoS) may be configured for the OAM subnet. See
'Quality of Service' on page 206 for details.
To Next Page
Loading...
