AudioCodes Mediant 8000 - Configuring the Redirect Number Manipulation Tel to IP Routing

Version 6.6 663 October 2014
Installation & Operation Manual 41. PSTN Gateway and IP-to-IP Applications
Parameter
Name
Type Provisioning
Type
Description
Source IP
Address
String
Up to 101 chars.
Instant Source IP Address
Number Type Enum
NotIncluded, Unknown,
InternationalLevel2Regional,
NationalLevel1Regional,
NetworkSpecificNetworkPISN,
SubscriberLevel0Regional,
Abbreviated, NotConfigured
Instant TON : Select the Number Type
assigned to this entry.
See 'Numbering Plans and Type
of Number' on page 666 for the
allowed combinations of Number
Plan and Number Type
parameters.
Number Plan Enum
NotIncluded, Unknown,
E164Public, Private,
NotConfigured
Instant NPI : Select the Number Plan
assigned to this entry.
Remove from
Left
Integer
0-211
Instant Stripped Digits From Left
Remove from
Right
Integer
0-211
Instant Stripped Digits From Right
Leave from
Right
Integer
0-255
Instant Number of Digits to Leave
Prefix2Add String
Up to 101 chars.
Instant Prefix to Add
Suffix2Add String
Up to 101 chars.
Instant Suffix to Add
41.5.5 Configuring the Redirect Number Manipulation Tel to IP
Routing
This section describes how to configure the Redirect Number Manipulation Tel to IP
routing.
 To configure Redirect Number Manipulation Tel to IP Tables:
1. Click
to access the Media Gateway status screen.
2. Select the desired SIP board.
3. In the Navigation pane, select SIP
Gateway/IP to IP Manipulation
Redirect Number Manipulation Tel to IP; the Redirect Number Manipulation Tel
to IP list screen is displayed.
4. Use the
or buttons to add or remove entries correspondingly