Version 6.6 403 October 2014
Installation & Operation Manual 34. Performance Measurements
4. Do one of the following:
• Select an existing PM Profile from the Profiles drop-down list. Proceed to
step 7.
• Select the performance measurements that you wish to collect. Proceed to
step 4.
5. In the Parameters List, select the parameters group that you wish to display
performance measurements (e.g., MG CPU Performance).
All parameters for the selected Parameter Group are displayed in the right pane.
6. In the Parameters List, right-click the Parameter group and check all parameters
for the group or individually check the desired parameters from the selected
Parameter Group.
7. In the Profiles pane, click the Save button. In the New Profile dialog, enter a
name for your new PM profile and click OK.
8. Click the Attach button to attach the specific PM Profile to the Media Gateway.
The "Question" dialog is displayed.
Figure 34-2: Do You Wish to Start Polling
9. Select Yes to start parameter's polling; the information dialog is displayed.
Figure
34-3: Polling Started
10. Verify that Polled Status changes to Polled.
To Next Page
Loading...
