Version 6.6 681 October 2014
Installation & Operation Manual 41. PSTN Gateway and IP-to-IP Applications
41.6.4 SIP to ISDN and ISDN to Release Cause Mapping
The SIP to ISDN and ISDN to SIP Release Cause Mapping tables enable the Mediant
8000 to map (up to 12) different SIP Responses to Q.850 Release Causes and vice
versa, thereby overriding the hard-coded mapping mechanism (described in the
Mediant 8000 Programmer's User Manual - Document # LTRT-914xx).
The following release cause mapping tables are supported:
SIP to ISDN Cause Mapping
ISDN to SIP Cause Mapping
41.6.4.1 Configuring SIP / ISDN Cause Mapping
This seciton describes how to configure SIP / ISDN Cause Mapping.
To configure SIP / ISDN Cause Mapping:
1. Click
to access the Media Gateway status screen.
2. Select the desired SIP board.
3. In the Navigation pane, select SIP
GW/IP to IP Trunk Groups and then
select the SIP / ISDN Cause Mapping table that you wish to configure (either
ISDN to SIP Cause Map or SIP to ISDN Cause Map); the corresponding SIP /
ISDN Cause Mapping Table list is displayed.
4. Use the
or buttons to add or remove entries.
5. Select a specific row and then in the configuration pane, click Release Cause
Settings; the corresponding Release Cause Settings screen is displayed.
6. Configure the relevant table entry parameters according to the tables below.
7. Click the Maintenance icon
and select Unlock to activate the configuration.
To Next Page
Loading...
