Installation & Operation Manual 622 Document # LTRT-92224
Mediant 8000
40.7 Account Group
Use the Account Groups table to define accounts per Trunk Groups (referred to as
Served Trunk Group) or to a Served IP Group for registration and/or digest
authentication (user name and password) to a destination IP address (Serving IP
Group). The Account Group can be used, for example, to register to an Internet
Telephony Service Provider (ITSP) on behalf of an IP-PBX to which the device is
connected. The registrations are sent to the Proxy Set associated with these Serving
IP Groups. A Trunk Group can register to more than one Serving IP Group (e.g.,
ITSP's), by configuring multiple entries in this Account Groups table with the same
Served Trunk Group, however with different Serving IP Groups, user name/password,
Host Name, and Contact User parameters.
40.7.1 Configuring Account Group
This section describes how to configure account groups.
To configure Account Groups:
1. Click
to access the Media Gateway status screen.
2. Select the desired SIP board.
3. In the Navigation pane, select SIP
SIP General Account Groups; the
Account Groups list is displayed.
4. Use the
or buttons to add or remove entries.
5. Select a specific row and then in the configuration pane, click Account Group
Settings; the Account Group Settings screen is displayed.
6. Configure the Account Group parameters according to the table 'Account Group
Parameters' below.
7. Click the Maintenance icon
and select Unlock to activate the configuration.
Table
40-16: Account Group Parameters
Parameter
Name
Type
Provisioning
Type
Description
Name String
Up to 20
chars.
Instant Textual, user-defined name assigned to the IP Group,
enabling users to identify it intuitively and easily.
To Next Page
Loading...
