Version 6.6 857 October 2014
Installation & Operation Manual 50. Accessing Advanced Status- Media Gateway Board via WEB
50 Accessing Advanced Status- Media
Gateway Board via WEB
The Media Gateway board's status is typically examined via the EMS GUI or via CLI
commands. The latter contain all required information for detailed operation,
configuration and maintenance of the Media Gateway board (for more information, see
Section 'Working with the Media Gateway Boards' on page 245).
However in certain scenarios, you may be asked by AudioCodes technical support to
collect some advanced status data of the specific Media Gateway board. In this case,
the WEB interface of the Media Gateway board may be used for collecting this data.
Note: The WEB interface of the Media Gateway board should only be used for
collecting debug data upon explicit request from the AudioCodes technical support.
It is not officially supported for any other use.
Access to the WEB interface of the Media Gateway board is disabled by default.
To enable access to the Media Gateway board's WEB interface:
1. Click
to access the Media Gateway status screen.
2. In the Navigation pane, select Troubleshooting and then in the configuration
pane, click Troubleshooting Settings; the Troubleshooting Settings screen is
displayed.
3. Configure the following parameters:
• Set Enable Web Access parameter to Enable.
• Set Web Access IP 1 parameter to the IP address of the PC that will be
used to access the Media Gateway board's WEB interface
• Set Web Access Password parameter to the password to be used when
accessing the Media Gateway board's WEB interface
Once access to the WEB interface of the Media Gateway board is enabled, access it
via the regular web browser (e.g., Internet Explorer) from the PC that was granted
access to the WEB interface as described above.
To Next Page
Loading...
