Version 6.6 175 October 2014
Installation & Operation Manual 24. SNMP Management Interface
24.2 Configuring Connectivity between the Media
Gateway and Additional SNMP Managers
Standard-compliant 3
rd
party SNMP managers (e.g. HP OpenView) may be used to
perform the following basic management tasks on the Mediant 8000 Media Gateway:
Trap notifications (alarms and events) collection
Monitoring of the Mediant 8000 status and configuration via standard MIBs (e.g.
IF-MIB or ENTITY-MIB)
For additional information see Programmer's User Manual - Document # LTRT-914xx.
Configuration of the additional SNMP managers may be performed as follows:
Up to two additional SNMP managers (called NMS and OSS) may be configured
via the Media Gateway Management Settings configuration screen in the EMS.
For each server, an IP address and trap port must be specified.
For the SNMPv3 protocol mode, additional SNMP managers may be configured
via the standard SNMP USM tables. This configuration may be performed directly
via the USM MIB or, alternatively, via the SNMPv3 Users Settings and SNMPv2
Notification Settings tabs in the Media Gateway Management Settings
configuration screen in the EMS.
If you chose to secure SNMP traffic via IPSEC/IKE protocols, in addition to the above
described configuration, you must create corresponding SC IPSEC Rules. For more
information, see Section 'Configuring IPSEC/IKE for Management Interfaces (on SC
boards)' on page 341.
To Next Page
Loading...
Need help?
General
