Installation & Operation Manual 862 Document # LTRT-92224
Mediant 8000
To configure ES mirror filters:
1. Click
to access the Media Gateway status screen.
2. In the Navigation pane, select Troubleshooting
ES Mirror Filters; the ES
Mirror Filters list is displayed.
3. Use the
or buttons to add or remove entries.
4. Select a specific row and then in the configuration pane, click ES Mirror Filter
Settings; the ES Mirror Filter Settings screen is displayed.
5. Configure the ES Mirror Filter parameters according to the table 'ES Mirror Filter
Properties' below.
6. Click the Maintenance icon
and select Unlock to activate the configuration.
Table
51-1: ES/6600 and ES-2 Mirror Filter Properties
Parameter Name Type Provisioning Type Description
Name String Instant The textual, user-defined name for the ES
Mirror Filter, enabling it to be identified
intuitively and easily.
Free User Text String Online Mirror filter description according to the ES
board’s internal filter syntax.
The syntax consists of one or more "filter
blocks"; each block consisting of the bits
range and a hexadecimal value. For
example filter "1-16=33 134-137=a"
matches IP packets that have 16 bits,
starting from bit 1, with hexadecimal value
33 (equivalent decimal value 51) and 4
bits, starting from bit 134, with
hexadecimal value A (equivalent decimal
value 10).
Dest MAC String Online Defines the value of the "Destination MAC
Address" element in the packet’s Ethernet
header (bits 1-48). The value must be
specified in hexadecimal format.
When set to ‘n’ matches all element
values.
To Next Page
Loading...
