Version 6.6 651 October 2014
Installation & Operation Manual 41. PSTN Gateway and IP-to-IP Applications
Table 41-2: Trunk Group Parameters
Parameter Name Type
Provisioning
Type
Description
Name String
Up to 20 chars.
Instant Textual, user-defined name assigned to
the Trunk Group enabling users to identify
it intuitively and easily.
Trunk Group ID Integer
1-99
Instant Trunk Group ID assigned to the channels.
The same trunk group ID can be used for
more than one group of channels.
Trunk group ID is used to define a group
of common behavior channels that are
used for routing IP to Tel calls. If an IP to
Tel call is assigned to a trunk group, the
call is routed to the channel or channels
that correspond to the trunk group ID.
You can configure the Trunk Group
Settings table to determine the method in
which new calls are assigned to channels
within the trunk groups.
Note: You must configure the IP to Tel /
Inbound Routing Table to assign incoming
IP calls to the appropriate trunk group,
otherwise calls will not complete.
First Trunk ID Integer
1-84
Instant Starting physical trunk number.
Last Trunk ID Integer
1-84
Instant Ending physical trunk number.
Starting Channel Integer
1-31
Instant Starting trunk's B-channel.
Ending Channel Integer
1-31
Instant Ending trunk's B-channel.
Note: The number of defined channels
must not exceed the number of the trunk's
B-channels (1-24 for T1 spans and 1-31
for E1 spans).
To Next Page
Loading...
