AudioCodes Mediant 8000 - Figure 45-5: Removing the PS from the Chassis

Version 6.6 805 October 2014
Installation & Operation Manual 45. Hardware Replacement
3. Pull on the handle in the middle of the power supply.
Figure
45-5: Removing the PS from the Chassis
 To insert a replacement power supply:
1. Push in the power supply until the front panel is flush with the chassis plate. The
green LED lights up.
2. Fasten the screws of the power supply.
3. Close the grill and fasten the screws at both sides.
4. In the EMS main status screen, verify that the Power Supply icon is green (as in
the figure below). In addition, verify that the Power Supply Аlarm is not displayed
in the Alarms Browser screen.
Figure
45-6: Power Supply Icon in EMS Status Screen
Figure 45-7: Power Supply Alarm in the Alarms Browser