AudioCodes Mediant 8000 - Installing the Solaris os on the SC Rev.1 Board; Verifying the Current Version of the Solaris os on the SC Board

Version 6.6 227 October 2014
Installation & Operation Manual 27. Working with the SC Boards
27.6 Installing the Solaris OS on the SC Rev.1 Board
The SC Rev.1 boards uses a special version of the SUN Solaris 9 ™ operating
system, provided by AudioCodes and configured for optimal Mediant 8000 hardware
and software performance. For a typical SC board that is preinstalled with a correct
version of the Solaris™ OS, there is no need to re-install it.
Note: When it becomes necessary to re-install the Solaris™ OS on SC boards, it is
important to use the Solaris OS installation image that is provided by AudioCodes.
27.6.1 Verifying the Current Version of the Solaris OS on the SC
Board
Version 6.6 of the Mediant 8000 software requires the SUN Solaris 9 ™ version 9/04
or later.
 To access the current version of the Solaris™ OS:
1. Connect to the SC board's CLI Interface. For more information, see Section
Section 'Command Line Interface' on page 107.
2. Login as root user. For more information, see Section Section 'Logging in as a
Root User' on page 115.
3. At the prompt, type cat /etc/version and press Enter. The current Solaris™ OS
version is displayed.
4. Verify that the Solaris™ OS version matches the version required by the specific
Mediant 8000 software.