AudioCodes Mediant 8000 - 32.1.2 Configuring the V5.2 Access Gateway

Installation & Operation Manual 296 Document # LTRT-92224
Mediant 8000
32.1.2 Configuring the V5.2 Access Gateway
Perform the following steps to configure the V5.2 Access Gateway application:

Configure Media Gateway board's PSTN parameters

Configure trunks that carry V5.2 links

Configure V5.2 Interfaces

Configure V5.2 Links

Configure V5.2 User Ports

Complete configuration by bringing V5.2 interfaces "In Service"
32.1.2.1 Configuring Media Gateway board's PSTN parameters
Prior to configuring the Media Gateway board's PSTN parameters, you must configure
the PSTN Media Gateway board parameters described in this section.
 To configure the Media Gateway board's PSTN parameters:
1. Click
to access the Media Gateway status screen.
2. Select the desired TP-8410 Media Gateway board.
3. In the Navigation pane, select Media and in the Configuration pane, click Media
Settings; the Media Settings screen is displayed.
4. The following Media Gateway board's PSTN parameters should be configured to
ensure the proper operation of the V5.2 Access Gateway application:
• Default Caller ID = ETSI(1)
• Caller ID Transport = Relay(1)
• ETSI Caller ID Type = ETSIBetweenRings(0)
32.1.2.2 Configuring Trunks for the V5.2 Access Gateway application
Prior to configuring the V5.2 Access Gateway application, you must configure DS1
Trunks as described in this section.
 To configure Trunks for the V5.2 Access Gateway application:
1. Click
to access the Media Gateway status screen.
2. Select a TP-8410 Media Gateway board.
3. In the Navigation pane, select PSTN
DS1 Trunks; the DS1 screen is
displayed.
4. Select a specific E1 trunk and in the Configuration pane, select Trunk Settings;
the Trunk Settings screen is displayed.