Version 6.6 287 October 2014
Installation & Operation Manual 31. Configuring the MGCP/MEGACO Protocols
Parameter Name Type
Provisioning
Type
Description
MEGACO RTP
Term Offset
Integer
0 –
2147483647
Online Defines the offset to be used in the MEGACO
RTP terminations.
To configure the Media Gateway Controller’s IP/FQDN addresses:
1. Click
to access the Media Gateway status screen.
2. In the Navigation pane, go to Call Control
MGCs and select the specific Media
Gateway Controller added/configured above.
3. In the Navigation pane, select CA Address; the MGC IP/FQDN Addresses list is
displayed.
4. Use the
or buttons to add or remove entries.
5. Select a specific row and then in the configuration pane, click CA Address
Settings; the MGC IP/FQDN Address Settings screen is displayed.
6. Configure the MGC IP/FQDN Address parameters according to the table below.
Table
31-6: MGC IP/FQDN Address Parameters
Parameter Name Type
Provisioning
Type
Description
Address Format Enum
IPv4(0),
DNS(2)
Online Defines the format of the MGC address.
IPv4 – up to 10 IP addresses may be
specified (for each Virtual GW); priority of
each address is defined by its Activity Order
property (lower values correspond to higher
priority)
DNS – only one MGC FQDN address entry
may be defined (for each Virtual GW); the
FQDN is resolved to the IP address through
the DNS protocol; up to 10 IP addresses may
be returned by the DNS
MGC Address String
Up to 30 chars
Online Defines the MGC Address – IP address or
FQDN
MGC Port Integer
0 – 65535
Online Defines the IP port number that MGC is
listening on.
Transport Type Enum
UDP, TCP,
SCTP
Online Defines the signaling transport type to be
used while communicating with this MGC.
Activity Order Integer
1 – 10
Online Defines priority of the MGC IP Address within
the specified Virtual Gateway. IP addresses
To Next Page
Loading...
