Version 6.6 563 October 2014
Installation & Operation Manual 40. General SIP Configuration
40.3 SIP Protocol Settings
The SIP Protocol Settings screen allows you to configure different aspects of the SIP
call control protocol implementation, provided by the Mediant 8000.
To configure SIP Protocol Settings:
1. Click
to access the Media Gateway status screen.
2. Select the desired SIP board.
3. In the Navigation pane, select SIP
SIP General and then in the configuration
pane, click SIP Protocol Settings; the SIP Protocol Settings screen is displayed.
4. Configure the SIP protocol settings as described in the tables below. Note that
parameters in Proxy Settings and Registration and Authentication tabs were
already described in previous chapters.
Table 40-5: SIP General Settings
Parameter Name Type
Provisioning
Type
Description
Transport Type Enum
UDP, TCP, TLS
Instant Defines SIP messages transport type.
Enable SIPS Enum
Disable, Enable
Instant Enables secured SIP (SIPS) connections
over multiple hops.
When Transport Type is TLS and
Enable SIPS is Disabled, TLS is used
for the next network hop only.
When Transport Type is TLS and
Enable SIPS is Enabled, TLS is used
through the entire connection (over
multiple hops).
When Transport Type is UDP and
Enable SIPS is Enabled, the connection
fails.
SIP Local Port Integer
1 – 65535
Instant Defines local UDP port used to receive SIP
messages.
TCP Local Port Integer
1 – 65535
Instant Defines local TCP port used to receive SIP
messages.
TLS Local Port Integer
1 – 65535
Instant Defines local TLS port used to receive SIP
messages. The value must differ from TCP
Local Port.
SIP Destination
Port
Integer
1 – 65535
Instant Defines SIP destination port for sending
initial SIP requests.
Note: SIP responses are sent to the port
specified in the Via header.
To Next Page
Loading...
