AudioCodes Mediant 8000 - Configuring SBC Alternative Route Reasons Table

Version 6.6 753 October 2014
Installation & Operation Manual 43. Session Border Controller (SBC) Application
Parameter
Name
Type
Provisioning
Type
Description
Request Type ENUM
All,
INVITE,
REGISTER,
SUBSCRIBE,
INVITEAndREGISTER,
INVITEAndSUBSCRIBE
instant Defines the type of incoming SIP
request.
43.11.3 Configuring SBC Alternative Route Reasons Table
The SBC Alternative Route Reasons table defines reasons for alternative routing rules
defined in the SBC IP to IP Routing table.
 To configure SBC Alternative Route Reasons:
1. Click the
button to access the Media Gateway status screen.
2. Select the SIP board.
3. In the Navigation Pane, select SIP
SBC SBC Routing Alternative Route
Reasons; the SIP Alternative Route Reasons list is displayed.
4. Use the
or buttons to add or remove entries.
5. Select a specific row and in the Configuration pane, click SBC Alternative Route
Reasons Settings; the SBC Alternative Route Reasons Settings screen is
displayed.
6. Configure SBC Alternative Route Reasons parameters according to the table
'SBC Alternative Route Reasons Parameters' below.
7. Click the Maintenance icon
and select Unlock to activate the configuration.
Table
43-7: SBC Alternative Route Reasons Parameters
Parameter
Name
Type
Provisioning
Type
Description
Release Cause Integer
400-699
Instant Defines the release cause of the call that
initiates alternative routing.