Installation & Operation Manual 70 Document # LTRT-92224
Mediant 8000
The SA/RTM board has LED indicators on its front panel that are used to indicate the
status of the board.
Table
12-4: SA-RTM LED Indicators
Label Function Color
FAIL Normal operation Off
Board failure Red
ACT Active board Green
Standby board Yellow
PWR Normal operation Green
Power is not supplied to the board Off
HOT SWAP Normal operation Off
Board is ready for extraction from the
chassis (latches are open).
Blue
12.3.1 SA/RTM RS-232 Console Port
The SA/RTM board provides RS-232 console port that may be used for connecting to
the corresponding SC board's Command Line Interface (CLI).
SA/RTM board's RS-232 console port is a 9-pin female D-type connector (P2). The
corresponding cable is a straight through cable with a 9-pin male D-type connector
(P1).
Table
12-5: SA/RTM RS-232 Console Port Connector
P1 Pin # Signal Name P2 Pin #
2 RX (Receive Data) 3
3 TX (Transmit Data) 2
5 GND (Ground) 5
To Next Page
Loading...
