Installation & Operation Manual 794 Document # LTRT-92224
Mediant 8000
To insert an SC board into the chassis, take these 6 steps:
1. Hold the board Vertical with the top of the board pointed upward.
2. With the black ejector/injector latches in the open (pulled out) position, insert the
board in the slot, aligning the board on the grooves on each end.
3. Ease the board all the way into the slot until the ejector/injector latches touch the
chassis. The blue hot-swap LED is lit.
Note: Push in the board until it is flush with the other boards. The SC board
requires extra pressure to ensure it is pushed in back sufficiently.
4. Press the two black ejector/injector latches on both ends inward, toward the
middle until you hear a click.
5. Wait for the hot-swap blue LED to turn off.
6. Fasten the screws on the front plate of the board to secure the board to the
chassis and to ensure that the board has an earth connection to the chassis.
45.2.2 Installing the Operating System (OS) on the Replaced SC
Board
The SC board typically has the proper version of the Operating System (OS) pre-
installed on it. Therefore there is usually no need to install the OS on a replaced SC
board.
In the unlikely event that your replacement SC board does not have the correct OS
version installed, install the correct OS version as described in 'The Operating System
on the SC Boards' on page 226.
45.2.3 Configuring IP Address on the Replaced SC Board
The replaced SC board must be configured to use the same IP address as the failed
one. See 'Configuring the Basic IP Network Parameters of SC Boards' on page 117
for a detailed configuration procedure.
To Next Page
Loading...
