Version 6.6 271 October 2014
Installation & Operation Manual 30. Time and Date Configuration
30.6 Configuring NTP Servers
This section describes how to configure the NTP servers.
To configure the NTP server:
1. Click
to access the Media Gateway status screen.
2. In the Navigation pane, select Time and Date
NTP Servers; The NTP Servers
list is displayed.
3. Use the
or buttons to add or remove entries.
4. Select a specific row and then in the configuration pane, click NTP Server
Settings; the NTP Server Settings screen is displayed.
5. Configure the NTP Server according to the table 'NTP Server Configuration
Parameters' below.
6. Click the Maintenance icon
and select Unlock to activate the configuration.
7. Repeat steps 4-6 for additional external NTP Servers that are available.
Note: The NTP Servers List always contains the EMS server as its first entry. You
may not delete or modify this entry. However you can lock or unlock this entry thus
enabling/disabling synchronization with EMS server.
Table 30-1: NTP Server Configuration Parameters
Parameter Name Type Provisioning
Type
Description
Name STRING[40] Instant Name of the NTP Server
IP Address STRING[20] Online IP Address of the NTP Server
Burst Mode ENUM – yes/no Online Burst mode for the NTP Server. This
mode enables sending of multiple packets
instead of a single one when server is
reachable.
iBurst Mode ENUM – yes/no Online iBurst mode for the NTP Server. This
mode enables sending of multiple packets
instead of a single one when server is
unreachable.
To Next Page
Loading...
