Installation & Operation Manual 420 Document # LTRT-92224
Mediant 8000
Affected board list – lists all of the Media Gateway boards to which the
Configuration Backdoor is applied
Affected board list with different values – lists all of the Media Gateway that
must be reset (locked/unlocked) to apply the Configuration Backdoor parameter
value.
36.1 Supported Actions
The following actions are available on the Media Gateway Board's Configuration
Backdoor:
Add – add a Backdoor Configuration parameter.
Remove – remove Backdoor Configuration parameter (backdoor must be locked
prior to using the remove action).
The BackdoorConfiguration is automatically deleted when all of the Media
Gateway boards to which it applies are deleted. When the Backdoor parameter
affects more than one board, a deleted board is removed from the Board IDs
attribute's range (except when the value range is defined as "all").
Lock – prepare the BackdoorConfiguration for removal. Locking the Backdoor
Configuration is allowed only when all of the relevant Media Gateway boards are
locked.
Unlock – activate the ConfigurationBackdoor. The backdoor parameter is applied
to the relevant Media Gateway boards according to the Update mode attribute.
36.2 Usage Tips
No validation is performed on the names and values of the Media Gateway
Board's parameters configured via the Configuration Backdoor. Make sure that
you provision the backdoor information precisely as instructed by Tech Support.
Configuration Backdoor is automatically removed during Online Software
Upgrade if the new version contains the configuration parameter. The Backdoor
parameter value is merged into the Media Gateway configuration database.
To Next Page
Loading...
