AudioCodes Mediant 8000 - Table 41-4: GW Inbound;Outbound Manipulation Set ID Parameter

Version 6.6 659 October 2014
Installation & Operation Manual 41. PSTN Gateway and IP-to-IP Applications
 To configure inbound/outbound Manipulation Set:
1. Click
to access the Media Gateway status screen.
2. Select the desired SIP board.
3. In the Navigation pane, select SIP
Gateway/IP to IP Manipulation and in
the Configuration frame, select GW Manipulation Frame ; the GW Manipulation
Settings screen is displayed.
4. Configure the GW inbound/outbound Manipulation set ID parameters according
to the GW inbound/outbound Manipulation set ID Parameters' below.
Table 41-4: GW Inbound/Outbound Manipulation Set ID Parameter
Parameter Name Type Provisioning
Type
Description
GW Inbound
Manipulation Set
Integer
-1 (Not Defined) to 19
Instant Inbound manipulation set ID for
GW. If configured, applies for all
incoming INVITE requests.
GW Outbound
Manipulation Set
Integer
-1 (Not Defined) to 19
Instant Outbound manipulation set ID for
GW. If configured, applies for all
incoming INVITE requests.
 To configure Calling Name Manipulation Table for IP to Tel Tables:
1. Click
to access the Media Gateway status screen.
2. Select the desired SIP board.
3. In the Navigation pane, select SIP
Gateway/IP to IP Manipulation
Calling Name Manipulation Table for IP to Tel; the Calling Name
Manipulations IP to Tel table is displayed.
4. Use the
or buttons to add or remove entries correspondingly.
5. Select a specific row in the Calling Name Manipulation Table for IP to Tel Table
and in the Configuration pane, click the corresponding link; the corresponding
Calling Name Manipulation Table for IP to Tel Settings screen is displayed.
6. Configure the Calling Name Manipulation Table for IP to Tel Table entry
parameters according to the table Calling Name Manipulation Table for IP to Tel
Table Parameters' below.
7. Click the Maintenance icon
and select Unlock to activate the configuration.