Installation & Operation Manual 640 Document # LTRT-92224
Mediant 8000
Note: If you configure an FQDN, make sure that the LDAPServerIP parameter is left
empty.
Search: For the device to run a search using the LDAP service, the path to the
directory’s subtree (or DN) where the search is to be performed must be
configured using the LDAP Search DN parameter. Up to three DNs can be
configured. The search key, or filter in LDAP references, which define the exact
DN to be found and one or more attributes whose values should be returned,
must also be defined.
If the connection to the LDAP server is disrupted during the search, all search
requests are dropped and an alarm indicating a failed status is sent to client
applications.
40.15.1 Configuring LDAP Server Parameters
This section describes how to configure the LDAP server .Up to five LDAP servers can
be configured. Each Media Gateway SIP board can be associated with one LDAP
server
To configure the LDAP Servers Table:
1. Click to access the Media Gateway status screen.
2. In the Navigation pane, select Services
LDAP; the SIP LDAP Servers list is
displayed.
3. Use the
or buttons to add or remove entries.
4. Select a specific row, and then in the Configuration pane, click LDAP Server
Settings ; the LDAP Server Settings screen is displayed.
5. Configure LDAP server parameters according to the table 'LDAP server settings'
below.
6. Click the Maintenance icon
, and then select Unlock to activate the
configuration.
Table
40-23: LDAP Server Parameters
Parameter
Name
Type
Provisioning
Type
Description
Name String Online Defines name of LDAP server.
LDAP Server IP Online Defines the LDAP server's address as
an IP address (in dotted-decimal
notation, e.g., 192.10.1.255).
The default is 0.0.0.0..
To Next Page
Loading...
