Version 6.6 187 October 2014
Installation & Operation Manual 26. Connecting the Media Gateway to the IP Network
Figure 26-2: An Example of “Two O & CM” Subnet Configuration
In order to change the IP Network Interfaces configuration, the Media Gateway must
be locked and all service on it must be stopped. The new IP network interfaces
configuration is not applied immediately; instead you must lock/unlock ES boards and
then unlock the Media Gateway as described in 'Activating New Network Interfaces
Configuration' on page 214.
To configure IP Network Interfaces:
1. Click
to access the Media Gateway status screen.
2. Lock the Media Gateway by clicking Lock in the toolbar. In the pop-up dialog,
confirm the type of Lock action and click Yes.
3. In the Navigation pane, click Networking and in the Configuration pane, click
Network Settings; the Network Settings screen is displayed.
4. In the Interfaces and VLAN Settings tab, configure the Interfaces parameter.
Note: VLAN table configuration is required only for the ES/6600 switch.
To Next Page
Loading...
