Part II
Getting Started
This part describes how to prepare your site and perform basic connectivity and
configuration of the Mediant 8000.
Take the following steps to install the new Mediant 8000 in your operational
environment (lab or deployment site):
Prepare your site for the Mediant 8000 installation. For more information, see
Section 'Site Preparation' on page
91.
Install the Mediant 8000 hardware (mount chassis on a rack and power it up). For
more information, see Section 'Hardware Installation' on page
98 and 'Powering
Up' on page 103.
Connect to the Mediant 8000 Command Line Interface. For more information, see
Section 'Command Line Interface' on page
107.
Connect the Mediant 8000 to the IP network. For more information, see Section
'Connecting to IP Network' on page
116.
Connect the Mediant 8000 to the PSTN network. For more information, see
Section 'Connecting to the PSTN Network' on page
122.
Install the Mediant 8000 software and perform basic configuration. Establish
connectivity with the Element Management System (EMS) for advanced
configuration and the Media Gateway maintenance. For more information, see
Section 'Software Installation and Configuration' on page
128.
Via EMS, complete configuration of the Mediant 8000and load to service all its
components (including Media Gateway boards). For more information, see Section
'Advanced Configuration' on page 154.
To Next Page
Loading...
