Version 6.6 189 October 2014
Installation & Operation Manual 26. Connecting the Media Gateway to the IP Network
Note: When configuring Control and Media Subnets,there is no need to lock/unlock
ES boards and then unlock the Media Gateway as described in 'Activating New
Network Interfaces Configuration' on page 214.
26.2.5.3 Configuring VLAN Tags for OAM Subnet
VLAN tagging for the OAM subnet primarily affects management traffic carried by SC
boards and is typically configured via the CLI interface, while establishing connectivity
with EMS server, as described in 'Establishing Connectivity with the EMS Server' on
page 180. However, it may also be configured via the EMS GUI as described below:
To configure VLAN Tags for the OAM Subnet:
1. Click
to access the Media Gateway status screen.
2. In the Navigation pane, click Networking and then in the configuration pane,,
click Network Settings; the Network Settings screen is displayed.
3. In the Interfaces and VLAN Settings tab, configure the OAM Tag ID parameter.
26.2.5.4 Configuring VLAN Tags for Media and Control Subnets
VLAN Tagging for Media and Control subnets applies to Media Gateway boards only
and doesn’t affect SC boards. The Media and Control Subnets VLAN Tags table is
used to configure Media and Control VLAN Tagging.
The Media and Control Subnets VLAN tags configuration is handled differently
according to the configured ES board:
ES/6600
For each Media and Control network interface, an entry in the VLAN tags table should
be created. This entry indicates the VLAN tag used. For untagged traffic, a default 0
(zero) VLAN tag entry is used. Multiple VLAN tag entries may be created for the same
network interface to allow multiple VLAN tags to be carried on the same network
interface.
ES-2
The Media and Control Subnets VLAN tags table is not relevant for this ES board; you
cannot configure this table in the Networks Settings screen.
For each Media and Control network interface, an entry in the Subnet table should be
created. This entry indicates the VLAN tag used. For untagged traffic, a default 0
(zero) VLAN tag entry is used. Multiple Subnet entries may be created for the same
network interface to allow multiple VLAN tags to be carried on the same network
interface.
To configure VLAN Tags for Media and Control Subnets for ES/6600:
1. Click
to access the Media Gateway status screen.
2. In the Navigation pane, click Networking and then in the configuration pane, click
Network Settings; the Network Settings screen is displayed.
To Next Page
Loading...
