Installation & Operation Manual 190 Document # LTRT-92224
Mediant 8000
3. In the Interfaces and VLAN Settings tab, go to the Media And Control Subnets
VLAN tags section.
4. Use
or buttons to add or remove VLAN tag entries.
5. For each VLAN tag entry, configure VLAN tag ID and corresponding Network
Interface.
Note: The VLAN Tags configuration requires locking of the Media Gateway and
consequent locking/unlocking of the ES boards, as described in 'Activating New
Network Interfaces Configuration' on page 214. Therefore, consider configuring
additional (spare) VLAN tags reserved for future use, to minimize system downtime
in case of future network..
To configure VLAN Tags for Media and Control Subnets for ES-2
1. Click
to access the Media Gateway status screen.
2. In the Navigation pane, click Networking and then in the configuration pane,
click Subnets; the Subnet Setting screen is displayed.
3. Use
or buttons to add or remove VLAN tag entries.
Note: The first Subnet is for the OAM and cannot be removed. In addition, it takes
the VLAN Tag ID from the Network Settings configuration (see 'Configuring Network
Settings').
4. For each Subnet entry, configure VLAN Tag ID and corresponding Network
Interface.
Note: The Subnet configuration does not require the locking of the Media Gateway
and consequent locking/unlocking of the ES boards. Only in the event of a change in
the OAM VLAN Tag ID at the gateway level requires the locking and unlocking of the
gateway.
To Next Page
Loading...
