Version 6.6 155 October 2014
Installation & Operation Manual 22. Advanced Configuration
22 Advanced Configuration
Once you have successfully connected the Mediant 8000 to the IP and the PSTN
networks, powered it up and established connectivity with EMS management
application, you should proceed to the configuration of site-specific features and the
Media Gateway applications.
The configuration tasks that must be performed depend on specific applications that
must be configured on the Mediant 8000 (SS7, SIP, MGC) and vary for each
deployment. Nevertheless, the following configuration tasks should be performed in
most of the deployment scenarios:
Configuring IP network connectivity (subnets, VLANs, interface separation, link
aggregation etc)
Configuring NTP Server
Configuring IP addresses of Media Gateway boards
Configuring parameters of Media Gateway Controller (MGC) or SIP Proxy
Configuring PSTN Connectivity
Configuring clock synchronization for PSTN interfaces
Configuring security settings
See 'Configuring & Operating the Media Gateway' on page 155 for a detailed
description of these and additional configuration tasks.
To Next Page
Loading...
