Version 6.6 621 October 2014
Installation & Operation Manual 40. General SIP Configuration
Parameter Name Type Provisioning Type Description
Authentication
Method List
String
256 char
Instant Defines SIP methods that the
device must challenge. Multiple
entries are separated by the
forward slash "\". If none is defined
(default), no methods
are challenged.
Enable SBC
Client Forking
Enum
No,Yes
Instant Enables call forking for USER-type
IP Groups.
No (default)
Yes = The device forks INVITE
messages (to up to five separate
SIP outgoing legs)
Contact Name String
299 char
Instant Local Host Name.
If configured, the gateway uses
the Contact Name string in its
Contact and Via headers as a host
name . It is used for working with a
specific IP group.
If this IP group parameter is empty,
the Contact header includes the
gateway numerical IP address
(default).
This feature is applicable for
Via/Contact headers in outgoing
INVITE to the specific IP group,
and the Contact header in
18x/200OK responses for incoming
INVITE from the specific IP Group.
The IP2TEL routing table can be
used to identify the source IP
group, from where the INVITE
message was received.
Note: To enable proper gateway
operation, the Contact Name
should be a valid FQDN.
To Next Page
Loading...
