Version 6.6 243 October 2014
Installation & Operation Manual 27. Working with the SC Boards
Therefore, you must use the following procedure to change the default user
passwords and make the SC board accessible via the IP network by configuring
the basic SC board’s network parameters.
To configure the basic SC board’s network parameters after the Linux OS
installation:
1. Use the RS-232 serial console to connect to the SC board’s CLI interface (see
'Command Line Interface' on page 107).
2. Login as root user (see 'Logging in as a Root User' on page 115).
3. To change the default password for acladmin user, type passwd acladmin and
enter the new password. To change the default password for root user, type
passwd root and enter the new password.
4. To configure the SC board’s IP network parameter, at the prompt type network-
config and press Enter.
[root@sc-board ~]# network-config
5. The current SC board’s network configuration will be displayed and you will be
prompted to change it. Type y and press Enter.
Current network configuration:
Hostname : sc-board
IP Address : 169.254.100.1
Subnet Mask : 255.255.0.0
Default Gateway : 169.254.0.1
Do you wish to change it? (y/[n]) : y
6. When prompted, enter the Hostname, IP Address, Subnet Mask and Default
Gateway for the SC board. It is strongly recommended to provide the same
values that were defined prior to the Linux OS re-installation.
Hostname : sc2-linux
IP Address : 10.7.21.4
Subnet Mask : 255.255.0.0
Default Gateway : 10.7.0.1
To Next Page
Loading...
