Installation & Operation Manual 888 Document # LTRT-92224
Mediant 8000
11. If interface separation of VLAN Tags configuration was changed, you will be
asked to reset (lock/unlock) ES boards prior to performing the unlock action on
Media Gateway . In such case, do the following:
a. Lock both ES boards:
SC-1 -- ~ -- /moGW
• lock esboard#9
Do you really want to lock /moGW/moSwitchBoard#9? [y/n] y
Performing lock action on /moGW/moSwitchBoard#9 - OK!
• lock esboard#19
Do you really want to lock /moGW/moSwitchBoard#19? [y/n] y
Performing lock action on /moGW/moSwitchBoard#19 - OK!
b. Unlock the ES board in slot 9:
SC-1 -- ~ -- /moGW
• unlock esboard#9
Performing unlock action on /moGW/moSwitchBoard#9 - OK!
c. Wait up to 10 minutes until the ES board in slot 9 completes the restart
operation and returns to service. Use the following command to determine
whether the ES board has completed the restart operation or not. Value
Enabled(1) indicates that board is back in service:
SC-1 -- ~ -- /moGW
• show esboard#9 param OperationalState
OperationalState=Enabled(1)
d. Unlock the ES board in slot 19:
SC-1 -- ~ -- /moGW
• unlock esboard#19
Performing unlock action on /moGW/moSwitchBoard#19 - OK!
e. Wait up to 10 minutes until the ES board in slot 19 completes the restart and
returns to service. Use the following command to determine whether the ES
board has completed the restart operation. Value Enabled(1) indicates that
the board is back to service:
SC-1 -- ~ -- /moGW
• show esboard#19 param OperationalState
OperationalState=Enabled(1)
12. Connect the network cables to port 20 on both ES boards (located in slots 9 and
19).
To Next Page
Loading...
