Installation & Operation Manual 152 Document # LTRT-92224
Mediant 8000
9. The configuration is copied from the SC board to operate as the active board and
a summary of the settings is displayed.
Copying Files...Done!
Configuration Summary:
Global SC IP Address : 10.7.13.90
1
st
SC IP Address : 10.7.13.91
2
nd
SC IP Address : 10.7.13.92
Enable Security : 0 (no)
SC Root Password : ******
10. You are prompted to start configuring. Type y and press Enter to commence the
configuration.
>>> Configure INET services ...
>>> Update /etc/inet/inetd.conf file ...
>>> Restore file /etc/inet/inetd.conf from the backup ...
>>> Update /etc/inet/services file ...
>>> Restore file /etc/inet/services from the backup ...
(This sequence is abbreviated)
11. After the configuration successfully completes, you are prompted to reboot the
SC board.
SC board must be rebooted to complete the re-configuration.
IMPORTANT: If you re-configure the Media Gateway software on both SC
boards, do not reboot the SC board in slot 1 until the re-configuration
of the SC board in slot 2 is completed.
REBOOT now (n/y) [y]: y
Are you sure (n/y) [y]: y
If you are installing the Mediant 8000 software on both SC boards, prior to this
installation (on the Standby SC board), you have waited for the SC board to
operate as the Active board to complete the reboot process.
Reboot both SC boards simultaneously by typing y and pressing Enter on the
respective SC board’s CLI interfaces.
12. The SC board reboots. It typically takes 2 minutes to complete the reboot
process. The Media Gateway software starts automatically after the SC board
completes the reboot process.
To Next Page
Loading...
