Version 6.6 151 October 2014
Installation & Operation Manual 21. Software Installation and Basic Configuration
client241::~# install
Found uncompressed Audiocodes installation package...
Verify installation package integrity...
SC Software Installation & Basic Configuration
1 - Change network configuration.
2 - Install the software.
3 - Change basic configuration.
4 - Copy basic configuration from Active SC.
5 - Uninstall the software.
0 - Quit.
Choose (0-5) : 4
5. You will be prompted to enter the IP address of the SC board to operate as the
Active board. Enter the corresponding IP address and press Enter.
Active SC IP Address [10.7.13.91]: 10.7.13.91
Verify that Active SC 10.7.13.91 responds to ping...
10.7.13.91 is alive
Configuration will be copied from Active SC 10.7.13.91 via SSH.
6. At the CLI user name prompt, enter the name of a regular CLI user on the Active
SC board (e.g., acladmin) .Refer to 'Command Line Interface Users' on page
113 for more details.
Please provide CLI user credentials:
CLI user name [acladmin] : acladmin
7. At the CLI user password prompt, enter the password of the specific CLI user
on the Active SC board (e.g., pass_1234).
CLI user password :*********
8. At the ROOT user password prompt, enter the password of root user on the
Active SC board (e.g., root).
ROOT user password : ******
Note: If you changed root password as part of the Active SC software basic re-
configuration, ensure that you enter the new root password at this prompt.
To Next Page
Loading...
