Version 6.6 119 October 2014
Installation & Operation Manual 18. Connecting to the IP Network
client238::~# install
Found uncompressed Media Gateway installation package...
Verify installation package integrity...
SC Software Installation & Basic Configuration
1 - Change network configuration.
2 - Install the software.
3 - Change basic configuration.
4 - Copy basic configuration from Active SC.
5 - Uninstall the software.
0 - Quit.
Choose (0-5) : 1
** **
** This option will change IP parameters of **
** current SC board. **
** **
Note: On SC boards with v5.6 or earlier software version installed, the install
command may produce the following error:
usage: install [options] file [dir1 ...]
In this case, type the command /install.pl instead.
6. The current network configuration is displayed; type y and press Enter to change
the current network configuration.
Current Network Configuration
Hostname : client33
IP Address : 10.6.8.33
Subnet Mask : 255.255.0.0
Default Gateway : 10.6.0.1
Do you wish to change it? (y/n) [n]: y
To Next Page
Loading...
